FMS-2000M Lite
LIT-12013692
9
6.
06
in.
4.
48
5 in.
3.
33
8 in.
0.548 in.
0.5 in.
4.311 in.
2.519 in.
2.878 in.
(63.983 mm)
(73.101 mm)
(109.499 mm)
(12.07 mm)
(13.919 mm)
(84.785 mm)
(113.919 mm)
(153.924 mm)
Use the retrofit ring in applications when the wall is existing.
Before you begin, make sure you have the following tools:
•
a drywall saw or an oscillating tool with a drywall saw blade
•
a drill and a 7/16 in. drill bit
•
a #2 Phillips head screwdriver
•
a 1/16 in. hex wrench
Note:
If you are want to install the FMS-2000M Lite in a space where the walls are already installed, use the retrofit ring to attach the
display to the wall.
1. Choose the location where you want to place the FMS-2000M Lite monitor.
2.
Orient the retrofit ring in the location that you want and keep the ring level. The default orientation is portrait, but you can also
choose to use landscape orientation.
3. Mark both screw holes and the corners of the rectangular section.
4. Use a drywall saw or oscillating tool to cut out the entire rectangular section inside the marked opening and drill the screw holes.
5.
Pull the pre-wired 4-conductor interface cable and the RS-485 BACnet MS/TP wires through the retrofit ring.
6.
If the 2-conductor power cable terminates at the monitor, pull the 2-conductor power cable through the retrofit ring.
7.
Insert the retrofit ring through the opening. Make sure that the four tabs make contact with the inside of the opening and then pull
the retrofit ring flush against the inside of the wall.
8.
Attach the monitor’s mounting bracket to the retrofit ring with the four included mounting screws. Use a #2 Phillips head screwdriver
to secure both the box and the bracket.
Note:
To avoid warping the mounting bracket, do not over-tighten the screws.
9. Connect the wires to the back of the monitor. For more information, refer to Figure 11.
10. Align the two slots on the back of the monitor with the tabs on the bracket, then swing
the monitor towards the wall so that the
single tab on the bracket slots into the back of the monitor.
11.
Insert the set screw into the hole on the side or bottom of the monitor’s housing when the monitor sits flush against the wall. Use a
1/16 in. hex wrench to drive the screw into the monitor until it engages with the tab.
After you mount the FMS-2000M Lite monitor, apply power to the monitor. The initial screen displays the Triatek logo and the Safety
Halo bezel lights up green to represent the current system status.
Installing the FMS-2000M Lite Thin Mount display for a retrofit application
