TriangleTube PRESTIGE Solo PA 110, Инструкция по установке и обслуживанию

Страница: 67 / 112

55
Chapt
er 10
CHAPTER 10 - START-UP PREPARATION
Requirements below must be met for warranty
coverage of Prestige Solo heat exchangers. A
thorough cleaning of any existing system, us-
ing approved heating system cleaning agents
is required prior to installation of the Prestige
Solo boiler. System should be treated with an
approved inhibitor after filling for long term
protection.
10.1. Boiler System Fluid Requirements
Do not use petroleum-based cleaning or seal-
ing compounds in the boiler system. Dam-
age to seals and gaskets in the system com-
ponents can occur, resulting in substantial
property damage, serious injury, or death.
System fluid including additives, must be prac-
tically non-toxic, having a toxicity rating or
Class of 1, as listed in Clinical Toxicology of
Commercial Products.
10.1.1 Boiler Fluid pH Level 6.0 to 8.0
Maintain the boiler fluid pH between 6.0 and 8.0. Check
using litmus paper or contact a water treatment com-
pany for a chemical analysis.
If the pH does not meet this requirement, do not oper-
ate the PRESTIGE Solo or leave the unit filled until the
condition is corrected.
10.1.2 Boiler Fluid Hardness Less Than 7 Grains
For areas with unusually hard water (hardness above 7
grains) consult a water treatment company.
NOTICE
WARNING
NOTICE
10.1.3 Chlorinated Water
Do not use the PRESTIGE Solo to heat a swimming pool
or spa directly.
Maintain the chlorine level of the water at levels consid-
ered safe for drinking.
10.1.4 Flush Boiler to Remove Sediment
The installer must flush the boiler system to remove
any sediment to allow proper operation of the PRES-
TIGE Solo .
Flush the system until the water runs clean and is free
of sediment.
For zoned systems, each zone should be flushed
through a purge valve. Purge valves and isolation
valves should be installed on each zone to allow proper
flushing of the system.
10.1.5 Cleaning of Old Boiler/System:
• Drain the existing system.
• Fill system with fresh water and cleaner, place exist-
ing boiler in operation and run all zones.
• Follow manufacturer’s instructions for proper clean-
er concentration and proper cleaning time.
• Thoroughly drain and flush system with fresh water
after cleaning.
• Install new boiler and fill system with fresh water
and proper amount of inhibitor.
• Verify pH and inhibitor level per inhibitor manufac-
turer’s specs; add inhibitor if necessary.
10.1.6 Cleaning of New Boiler/System:
• Install new boiler and flush system with clean water
to remove any debris.
• Fill system with fresh water and proper amount of
inhibitor.
• Verify pH and inhibitor level per inhibitor manufac-
turer’s specs; add inhibitor if necessary.