Safety Information
1 Safety Information
The user must have read and understood this documentation before carrying out any operation on Tri-
amec Motion AG hardware. Please contact Triamec Motion AG in case of missing information or doubt
regarding the installation procedures, safety or any other issue.
Caution
Caution
Triamec Motion AG disclaims all responsibility to possible industrial accidents
and material damages if the procedures & safety instructions described in this
manual are not followed.
Never use the device for purposes other than those described in this manual.
The device must be installed by trained personnel only andin accordance with applicable regula-
tions of the respective country concerning both safety and EMC aspects.
Troubleshooting and servicing are permitted only by Triamec Motion AG technicians.
The safety symbols placed on the device or written in this manual must be respected.
If this device is integrated into a machine, the manufacturer of this machine must ensure that it ful-
fills the 2004/108EC directive on EMC before operating the system.
Danger
Danger
To avoid electric arcing and hazards to personnel and electrical contacts,
never connect/disconnect the device while the power source is on.
Danger
Danger
Power cables can carry a high voltage, even when the motor is not in motion.
Disconnect the hardware from all voltage sources before it is disassembled
for servicing.
After shutting off the power and removing the power source from the equip-
ment, wait at least 10 minutes before touching or disconnecting parts of the
equipment that are normally loaded with electrical charges (such as capaci-
tors or contacts). Measuring the electrical contact points with a meter before
touching the equipment is recommended.
Caution
Caution
The device contains hot surfaces and electrically-charged components during
operation.
Caution
Caution
The maximum AC power supply connected to this hardware must comply
with the parameters outlined in this guide.
In a one phase configuration, never connect the phase without the corre-
sponding neutral wire.
HWTP50-TP350_E_HardwareManual_EP008
2022-08-08
3
/
20