Triacta PowerHawk 6320, Руководство по установке

Страница: 9 / 32

NOT
FO
R DI
ST
RIBUTIO
N
WI
THO
U
T T
H
E
CON
S
ENT
OF
TRIACTA PO
WER
Triacta Power Technologies PowerHawk 6320
Installation 5
The installer must provide the following tools and equipment before proceeding with the
installation:
• an appropriate breaker for the type of panel: single-, poly-, or three-phase depending on
the installation, or a fused disconnect switch
• current/voltage meter to test the phasing of panels
• phone or butt set to test the phone line
• RJ11 junction box
• RJ11 splitter to tap into the existing junction box
• RJ11 patch cable
• xDSL filter if required (many businesses have their internet access on the same line as the
fax)
• RJ45 Ethernet patch cable
• 4-wire 14 AWG (1.63 mm
2
) cable for three-phase PowerHawk installation
• 3-wire 14 AWG (1.63 mm
2
) cable for single-phase or poly-phase PowerHawk installation
• small flat-head screwdriver
• crimping tool
• 22 AWG to 18 AWG crimps
• wire strippers
• four 1-inch (25-mm) #8 mounting screws suitable for the selected mounting surface
Site planning
1. Determine the number of PowerHawk units to be installed and ensure there is adequate
space.
2. Determine the number of analog phone lines or ethernet drops required, and ensure they
are installed before installing the PowerHawk unit.
3. Determine the number and types of meters or monitors required (single-phase, poly-phase,
or three-phase).
Access to power and lighting
The installation site must be supplied with access to the main electrical panel and any
sub-panels. Portable or permanent lighting must be available to provide the installers with a
clear view of the equipment and of the installation environment. Each installation may vary
depending on physical site restrictions.