11
Model 212B-FF Flange Facer
92-0291 : Rev. 921230
CAUTION:
NOTE:
Check the position of the Tripper Shaft for feed rate. (Refer to "Feed Rate" later in
this chapter.)
Attach the proper power supply line to the Model 212B.
Check that the air supply filter/regulator/lubricator (FRL) is installed and set
properly.
Turn the Motor on. (Refer to the chapter "Cutting Speeds and Feeds".)
The actual machining operation will begin when the cutting surface of the
Tool Bit comes in contact with the flange.
If the pipe end is not square to the pipe axis, the Tool Bit will contact only a small
segment of the flange during each revolution.
To avoid Tool Bit damage, the Tool Bit must clear the highest point of the flange on
the first revolution.
After the cut is finished, release the Air Motor Lever to stop the Cutting Head
rotation.
Loosen the Mandrel Draw Nut and remove the BEVELMASTER
TM
from the pipe.
If the next flange is the same as the previous flange, install the machine on the pipe
and follow the sequence starting with “Position and clamp the Model 212B….”
Location of the various Screws
