tri-art audio S Series, Руководство пользователя

Страница: 14 / 20

use &
guidelines
Adding the Grease:
Once you completed your initial measurements, located the wooden sticks and apply a ¼ of
the tip of grease into the coned cup and then place the tonearm back on the bronze spike
and get it to seat correctly. At this point check your tracking force, reset if necessary, your
VTA and fine tune your azimuth settings.
Once you have achieved your desired cartridge, Azimuth and VTA set, you can set the
final resting position of your tonearm. There are four (4) Allen Screws on the side that can
be accessed with the enclosed Allen keys, remove one of the support screws and lower or
raise the bar to get the holder to a level position.
Turn the power switch on and watch the turntable platter begin to spin. Place a record
directly on the platter (do not add rubber or felt platter mats as apart from degrading the
wonderful sound of the bamboo platter, can change the settings you have just completed.
Carefully place the arm over and carefully manually lower (there is no cuing arm) the
cartridge on the record. When removing a record or placing one on we recommend not
turning off the table. Following these instructions will result in many years of exceptional
trouble-free performance.