TREX Horizons, Руководство по установке

Страница: 8 / 13

A
B
C
D
E
G
H
TREX FENCING GATE
INSTALLATION GUIDE
COMPONENTS FOR SECLUSIONS AND HORIZONS SINGLE GATES
5x5 Fence Post
Fence Gate
A
Steel Post Stiffener
Fence Hinge (2)
E
Fence Latch
Striker
Gate Handle (2)
1-1/2" Self-Taping Screws (20)
l" Self-Tapping Screws
BEFORE YOU BEGIN
» Read all instructions before installation.
» Follow Installation Instructions to lay out fence and dig holes.
STEP 1: SET THE GATE POSTS
A. Slide the Steel Post Stiffener into the Hinge post.
The open side of the steel stiffener should be
placed so it faces away from gate opening.
B. Set posts into post holes. Hole dimensions for
standard gate openings are 30" deep by 12"
wide. However, consult local conditions, codes,
and standard building practices for actual post
depth.
C.
The opening (measuring from the inside face of
one post to inside edge of the other post) for a
Standard Size Trex Seclusions Gate panel should
be 46-1/4". Inside faces of posts should be plumb
and parallel. (**The opening for a Standard Large
Size Trex Gate panel is 65-3/4" wide). Custom
heights and widths are possible.
Notes:
Due to concrete cure times, set the gate posts 2-3
days before gate is installed.
B
Gate Uprights
Check for level.
C.
C
A.
C
HINGE POST
®
All gate panels are built 1-7/8" narrower than the
opening to allow hardware to function properly.
, _______ 46-1/4"*-*-------,
If the Hinge Post is not connected to a fence panel or
if a large gate panel is used, it may be necessary to
use a Heavy Duty Steel Post Stiffener or to fill the
post with concrete for additional strength.
©FDS Distributors 2018