13
-
Push the comb (11) downwards or upwards to set the desired level (Fig. 14), as indicated
in the following table:
Setting
Length (after trimming)
1
4 mm
2
5 mm
3
6 mm
Note:
when you are trimming for the first time, you may want to start with the longer
length (position 3) to familiarize yourself with the appliance.
-
Turn on the unit by moving the operation switch (3).
-
Move the device slowly in the direction of hair growth: since the hair does not grow in
the same direction, it is recommended to move the clipper in various directions (see Fig.
15 for reference).
-
For best results, make sure that the flat part of comb is always in contact with your skin.
-
Make several passes over the head to ensure you cut all the hair you need to.
-
Regularly remove remaining hair on the comb. If you need, switch off the appliance to
remove the comb (10) and clean the cutting blade.
CLEANING
CAUTION: disconnect the plug from the electrical power outlet before performing any maintenance
and cleaning on the unit.
After each cut, clean the trimmer or hair-cutting comb, or the shaver attachment by blowing on them or using
the cleaning brush to remove the hair.
Use the supplied oil to lubricate the blade. 2-3 drops are enough if you are going to perform this operation
quite often. Use only lubricating oil provided, or other similar, but not acid oils. For cleaning the unit, do not
immerse the main body in water or other liquids, but clean it with a soft, damp cloth.
TECHNICAL FEATURES
•
Power supply: AC 100-240V ~ 50/60Hz / DC 3V – 1000mA
•
Operation time 45 mins
•
2 x 600mA Ni-Mh battery
TECHNICAL SHEET POWER SUPPLY: LW-030100EU
Information
Value
Unit
Input voltage
100 - 240
V
Input AC frequency
50/60
Hz
Output voltage
3.0 a.C.
V
Output current
1.0
A
Output power
3.0
W
Average active efficiency
71.59
%
Efficiency at low load (10 %)
0.05
%
No-load power consumption
100 - 240
W
