Treston
• 156 Bluffs Court, Canton, GA 30114
Tel. 800.437.6772 • Fax 770.720.6584 • [email protected] • www.treston.us
ASSEMBLY INSTRUCTIONS
Cornerstone Bench
905998
10/17/19
7 (7)
STEP SEVEN:
Insert glide into bottom of telescoping leg
tubes. Attach second nut to glide stem and tighten. (In the
above photo, the glide is placed in the shortest position.)
STEP NINE:
Attach laminate work surface using
provided hardware. For phenolic tops, please refer to
work surface instructions, right.
STEP EIGHT:
Rotate table into upright position.
LAMINATE
Treston laminate tops assembled with wood screws
provided.
PHENOLIC
DO NOT USE provided screws from the hardware
pack provided with the table.
These screws are for
laimate work surfaces only.
Treston phenolic tops can be assembled in 2 ways:
• Mechanical fasteners
- Screws to be provided by the
installer. Pre-drill a pilot hole in the bottom of the work
surface, taking care to keep from penetrating through
the top. The pre-drilled hole should be the same length
as the screw shaft. The screw should be slightly larger
in diameter than the pilot hole. Use a coarse threaded
screw, wood or machine.
• Adhesive
- Provided by the installer. Use 100% silicon.
Apply several “spots” or a continuous bead to the top of
the table frame. Position the work surface as centered on
the frame and let cure for 12 hrs at room temp.
