Treston
• 156 Bluffs Court, Canton, GA 30114
Tel. 800.437.6772 • Fax 770.720.6584 • [email protected] • www.treston.us
ASSEMBLY INSTRUCTIONS
Cornerstone Bench
905998
10/17/19
6 (7)
STEP ONE:
Lay rear case assembly with back side
down. Attach depth kit rails to the legs with the work
surface support lips facing up, flush with the inside of the
leg. Attach the depth kit rail using M8 hardware, inserting
threaded nut plate into legs.
NOTE
: Wait to attach lower depth kit rails until step 3,
after telescoping legs have been inserted.
STEP THREE:
Attach lower depth kit rails to legs
using M8 hardware. Insert the threaded nut plate into
telescoping leg. M8 bolts with washers will hold depth kit
rail, leg tube and telescoping leg together.
STEP FIVE:
Attach front leg/front rail assembly to the
rest of the frame with M8 hardware and nut plates. Insert
telescoping legs into leg tubes before attaching lower
depth kit rails. (see steps 1-3). Tighten all bolts.
NOTE:
If adding a bottom shelf, depth kit rails should be
mounted with lip facing out to support shelf brackets.
STEP TWO:
Insert telescoping legs into leg tubes. Align
holes with outer side of the leg tubes. Set to desired
position/height of the table.
STEP FOUR:
With rear case still laying flat on the floor,
lay front leg and front rail assembly onto depth kit rails,
keeping the depth kit rails flush with the outsides of the
front assembly.
STEP SIX:
Floor glides will each require 2 nuts for
mounting. Before attaching floor glides to legs, place first
nut on bolt in desired location.
work surface
support lip
