tresnar 6686, Инструкция по эксплуатации

Страница: 29 / 32

TCD-108
6686
“EGA Spółka z o.o.” Spółka Komandytowa ul. Rzeczna 1, Nowa Wieś Rzeczna
83-
200 Starogard Gdański tel,/fax:+48 58 56 300 80 www.ega.com.pl
27
selected. For taking out the drill bit, removing a stuck drill bit, or unscrewing screws,
counter-clockwise operation should be selected.
Choosing torque
The driver is equipped with a ring, which can be used for setting the toque when driving
screws. The ring has 18 settings, from 1 to 17, and a drilling setting.
Using a given setting (from 1 - 17) means that the clutch is set to an assigned toque. This
makes it possible to prevent a screw from being driven too far or being damaged. Different
torques should be used for different screws and materials.
Always start with a low torque and increase gradually until the desired result is achieved.
For drilling in metal, wood or plastic, set the ring, so that the indicator points to symbol.
Installation and removing drills to/from the keyless chuck
Caution: Disconnect the battery from the driver or put the rotation direction switch (3) in the
middle position to secure the machine from being started by mistake, which could in turn
cause harm to the user.
To remove a drill (or a working bit) from the chuck hold the lower ring of the grip (the one
close to the tool body) with one hand and rotate, with the other hand, the upper ring
anticlockwise to enlarge the chuck opening.
To install a drill (or a working bit) in the chuck hold the lower ring of the grip (the one close to
the tool body) with one hand and rotate, with the other hand, the upper ring clockwise to
achieve locking of the drill /bit in the chuck. Drills (or other working bits) must be moved to
the full depth of the chuck opening.
Drilling boreholes
1.To drill deep boreholes carry out your job gradually, drill to lower depths and remove the
drill from the borehole from time to time to remove borings from the borehole.
2.To drill large diameter boreholes it is recommended to start with drilling a low-diameter
borehole and then expand it to the desired diameter. It prevents the tool from overloads.
3.When the drilling bit is seized during working switch immediately tool off to prevent it from
being damaged. Switch the rotations direction to the anticlockwise rotations and then
remove the drilling bit from the borehole.
4.Keep the drill aligned with the axis of the borehole. The drilling bit must be positioned
perpendicularly to the surface of the machined material. When the perpend circularity fails
to be maintained the drilling bit may be seized or broken or, under extreme circumstances,
the operator may be injured. Rotation speed of the drill spindle is controlled by the force the
power switch is depressed with.