TID-13/1050
4659
“EGA" Spółka z o.o. Spółka Komandytowa ul. Rzeczna 1, Nowa Wieś Rzeczna
83-
200 Starogard Gdański tel/fax:+48 58 56 300 80 www.egatools.com
20
a dust mask.
4.The work piece must be secured in a fixture or vise. Unstable support may lead to
jamming of the drill, which will result in loss of control or injury.
5.Do not just push a drill that resulted in a dismissal of the motor. The drill must be able to
cut the material. This allows you to get better, the quality of drilling, and the tool is less
exploited.
6.After drilling, do not touch the drill. The drill is then extremely hot.
7.Use only accessories work that are in good condition.
8.Never reach under the work piece.
9.Periodically check the tightness of all nuts, bolts and other fasteners.
10.In the workplace, do not leave your rags, fabrics, wires, cords, etc. In the place of work
may not be things that could be tripped over.
11.After some time the carbon brushes are subject to wear and see them bigger sparks.
This means you need to replace the brushes, and the lack of exchange will damage the
engine.
Features
Before using the tool, refer to the following functions. (Fig.1):
1. Mode switch "drilling / impact drilling"
2. Depth gauge
3. Fast-chuck chuck
4. Additional handle
5. Rotation lever
6. Rotation knob
7. Rotary switch
8. Lock button
Installation
Note!
Fig.1
