“EGA Spółka z o.o.” Spółka Komandytowa ul. Rzeczna 1, Nowa Wieś Rzeczna
83-
200 Starogard Gdański tel/fax:+48 58 56 300 80 www.ega.com.pl
Difficulty getting an arc, interrupting an arc
• Check the quality of the electrode used, poor quality electrode will not allow you to obtain
the required high quality weld.
• The electrode is damp and therefore the arc is not stable, the weld defect is increasing and
the weld quality deteriorates.
If you use a cable whose length has caused an excessive drop in output voltage, you should
shorten it as short as possible.
The output current does not reach the rated value
• A sudden increase in the supply voltage will result in a mismatch of the output current. If
the supply voltage is below the rated value, the maximum value of the output current of the
welder will most likely also be lower than the rated value. Current instability may be caused
by the following:
- Change the voltage in the mains.
- Serious power interruptions or interruptions
Caused by other current collectors.
Excessive splashes
• Too high current, too small electrode diameter.
Reverse polarity, electrode connection to power cathode, welded element to positive
electrode, polarity must be changed.
Maintenance
• Check the technical condition of the welder every day.
• Check that the current wires are in good working order and do not show any signs of
mechanical damage or the condition of both handles.
• Keep the power cord current.
• During work, care must be taken to free the air around the unit so as not to hinder the
operation of the cooling fan.
• As the defects develop, they must be removed at regular intervals. Every now and then,
we should clean the interior of the welder with compressed air.
Accessories
1. Inverter inverter
– 1 pc.
2. Welding cable with electrode holder - 1 pc.
3. Terminal cable with clamps - 1 pc.
4. Protective mask + quick welding - 1 set.
5. Brush with hammer - 1 pc.
6. Manual
– 1 pc.
