Tresanti 1356692, Руководство пользователя

Страница: 22 / 32

22
ODP34128REV.1
OPERATION
- Lock Button:
1. Press this button for 3 seconds to lock the touch controls. This will prevent accidentally engaging the controls after the
desired height has been set. Press the button for 3 seconds again to unlock.
Converting Units:
1. Continuously hold the H2 and H3 (H2+H3) buttons for 10 seconds at the same time, to toggle between metric and
imperial measurements (inch/cm)
In “inch” state, keep pressing H2+H3 for 10 seconds, release, change to “inch”.
In “cm” state, keep pressing H2+H3 for 10 seconds release, change to “cm”.
Display:
1. The display will indicate the height of the desk (inches). After five seconds, the digital readout will automatically fade
away.
2. To program the height presets (H1-H3) set the desk to the desired height and then press and hold the desired preset for
3 seconds. The display will blink once preset is successfully programmed. The desk will automatically return to the set
height when the corresponding preset is touched.
3. Touch and hold the
▼
button to lower the desk and release when it arrives at the desired height. The desk is at the
lowest height setting when “bot” is displayed.
4. Touch and hold the button to raise the desk and release when it arrives at the desired height. The desk is at the
highest height setting when “top” is displayed.
USB Ports:
There are 2 USB ports (5V/2.4 A for each port) suitable for charging devices with 2.4 A charging power requirement (or
lower). The USB ports will pause charging temporarily when the height of the desk is being adjusted and the motor
is in use.
Reset/Initial Calibration: Be sure to clear the desk of all items to avoid obstruction during the reset.
Hold the “
▼
” and “ ” buttons together to perform a system reset. The reset will begin after 3 seconds and the
desk will begin to move down while displaying “RES”. Continue to hold “down” and “up” as the desk cycles
through height changes until there is a BEEP and the desk display reads “BOT” changes until there is a BEEP and
the desk display reads “BOT”.
Control Panel
2 USB Ports (5V/2.4 A, for each port)