- 15 -
PROBLEM
POSSIBLE CAUSE
SOLUTION
Screen Indicator: E1
Connection failure between screen and control
unit.
Secure connections.
.t
r
o
p
p
u
S
l
a
c
i
n
h
c
e
T
y
fi
t
o
N
.
e
r
u
li
a
f
l
o
r
t
n
o
c
c
it
a
t
s
o
m
r
e
h
T
2
E
:
r
o
t
a
c
i
d
n
I
n
e
e
r
c
S
Screen Indicator: E3
Temperature probe reading failure.
Notify Technical Support.
Screen Indicator: E4
Thermostatic control failure when maximum
temperature is reached.
Disconnect and reconnect the system / Notify
Technical Support.
Screen Indicator: E5
Safety stop. Temperature above 50°C.
Disconnect and reconnect the system / Notify
Technical Support.
The hot water does
not reach the selected
temperature.
The hot water is not between 55°C and 65°C.
Increase the water inlet temperature.
The hot water pressure is lower than the cold.
Increase the hot water pressure or reduce the cold.
The cold and hot pipes have been reversed.
Reverse the pipes.
The thermostatic cartridge is dirty.
Notify Technical Support.
lter.
The cold water
temperature is higher than
the selected temperature.
The cold water pressure is lower than the hot.
Increase the cold water pressure or reduce the hot.
The cold and hot pipes have been reversed.
Reverse the pipes.
The thermostatic cartridge is dirty.
Notify Technical Support.
lter.
Touch buttons fail to
operate.
.
y
l
p
p
u
s
r
e
w
o
p
k
c
e
h
C
.r
e
w
o
p
o
N
lters.
ow or
temperature.
Very imbalanced cold/hot water pressures.
Equalise the pressures; 3 bar is recommended.
No water comes out.
Malfunction in the cold or hot water supply
Check the water supply
The anti-scalding system has been activated
Disconnect and reconnect the system / Notify the
technical service centre
.
e
r
t
n
e
c
e
c
i
v
r
e
s
l
a
c
i
n
h
c
e
t
e
h
t
y
fi
t
o
N
n
o
it
c
n
u
fl
a
m
m
e
t
s
y
S
ow. The safety system cuts the
ow if the temperature is above 50°C. Press the ON/OFF button to restart. System limited to 46°C maximum temperature. Minimum
temperature 25°C. The equipment is capable of closing active outlets if the power supply fails.
• Operating mode.
- The system starts at 38 °C by default.
- The selected temperature level is indicated numerically and on a colour scale:
Blue: 25°C - 33°C / Fuchsia: 34°C - 40°C / Red: 41°C - 46°C
- If 3 seconds go by after selecting a temperature and an outlet is active, the real temperature will blink on-screen until the preselected
temperature is reached.
- Opening and closing outlets does not change the preselected temperature.
automatically when it has been running for 15 minutes.
: Press the ON/OFF button.
- The system will close if an outlet is active.
.
except the ON/OFF button.
1- Clean the product periodically with water or pH neutral liquid detergent.
2- Rinse with clean water and dry with a soft cotton cloth.
3- Do not use acidic or abrasive detergents.
MAINTENANCE
