TRENDnet TW-H6W1IR, Руководство пользователя, Страница: 23 / 165

TW-H6W1IR ISDN Remote Router
Installation 15
For the initial configuration of your TW-H6W1IR, you must use an
RS-232 console connection, either to a computer running serial
communications software or to a serial data terminal.
After the router has been successfully installed and the initial
configuration is complete, you can continue to modify settings through
the console, or you can change configuration settings through a remote
Telnet connection or through a web browser. See the chapters entitled
Configuration and Management and Using Telnet for detailed
instructions on using Telnet to configure your TW-H6W1IR.
A Warning on Connection Cables
ISDN and Ethernet cables are very similar to each other. It is important
that you use the correct cable for each connection; otherwise, your
router could be damaged.
Before connecting or disconnecting an RS-232 cable between two
devices, turn both devices off to avoid any chance of damaging them.
Step 1 - Setting up the Console
The initial setup of the TW-H6W1IR, requires connecting a console
to the 9-pin RS-232 Diagnostic port on the router’s rear panel. A
serial cable is supplied with the router in order to make this
connection. A console can be a terminal, such as a VT-100, or a
normal PC running terminal emulation software (such as Microsoft
HyperTerminal, included with Windows). The terminal emulation
software needs to be configured to the following parameters:
??
VT100 terminal emulation