The information contains in this file is a startup guide for using the
TE-4010 with TRENDnet-View ver. 1.1.
Before you begin, make sure you have the following described environment:
o A PC with a network card installed and properly configured (IRQ and I/O
base address are set). We use TE-16XP/CT, but you can use any NE-2000
compatible cards.
o Windows ver. 3.1 is properly installed on the PC's hard drive.
o The PC is physically connected through a RJ-45 cable with TE-4010. It does
not matter which port is connected to.
o No network software (or driver) is loaded in either CONFIG.SYS and
AUTOEXEC.BAT files. A "clean boot" is preferred.
o Need two pieces of 25-pin serial cable and make the connection from hub's
OUT-OF-BAND management port -> serial cable -> null modem (provided with
TE-4010) -> serial cable -> PC's com1 or com2 port.
1. Start Windows 3.1.
2. Run TERMINAL program in the ACCESSORIES Group.
3. Make sure you have the following configurations:
o Full duplex
o Asynchronous communication
o Data: 8 bit
o Stop bits: 1
o Parity: none
o Baud rate: 9600
o COM1 or COM2 port
4. Press enter several time to go into the setup menu described on page 25
of the TE-4010's manual. Do not type any password.
5. Record the Hub IP Address. For example, 192.132.65.36. You need the IP
address for the TRENDnet-View software. We will use this number for this
example setup procedure.
6. Exit the setup program by pressing ESC key.
7. Exit the TERMINAL program without saving the current configuration. You
are now ready to load TRENDnet-View software. You can disconnect the
serial cable and the null modem.
8. Load TRENDnet-View disk in the floppy disk drive.
9. From program manager, select Run... in the File menu. A dialog box
appears.
10. Type "A:INSTALL" (do not type " ") and click the OK button.
11. In the TRENDnet-View Configuration dialog box, modify the following
information where appropriate:
o IP Address: 192.132.65.xxx xxx, leave it at default
o Gateway IP Address: 192.132.65.xxx xxx, leave it at default
o Subnet Mask: 255.255.255.0
o Network card: NE-2000
o IRQ Number: xx xx, setting for the network card
o I/O Port: xx xx, setting for the network card
12. Type in your password for any future modification of the above settings.
Do not exit from Windows 3.1.
13. Load the TE-4010 SNMP Module disk in the floppy disk drive. The diskette
is included with TE-4010.
14. From program manager, select Run... in the File menu. A dialog box
appears.
15. Type "A:INSTALL" (do not type " ") and click the OK button.
16. The installation is automatic. All files will be copied to where
TRENDnet-View is installed.