TRENDnet PoE Web Smart Switch Series, Руководство пользователя, Страница: 104 / 138

© Copyright 2018 TRENDnet. All Rights Reserved.
86
TRENDnet User’s Guide
PoE Web Smart Switch Series
Add Servers ( Authentication Method)
Security >
Terminal Access Controller Access Control System () provides centralized
security user access validation. The system supports up-to 5 servers.
provides a centralized user management system, while still retaining
consistency with RADIUS and other authentication processes.
The protocol ensures network integrity through encrypted protocol exchanges
between the client and server. The user-assigned parameters are
applied to newly defined servers. If values are not defined, the system defaults
are applied to the new servers.
1. Log into your switch management page (see “ Access your switch management page ”
on page 5).
2. Click on Security and click on .
3. Review the settings.

Server Priority – Enter the Server priority (Highest: 1, Lowest: 5).

Server IP Address – Enter the Server IP address.

Server Port – Enter the port number via which the session occurs. The
default port is port 49.

Timeout – Enter the amount of time (in seconds) the device waits for an
answer from the server before retrying the query, or switching to the
next server. Possible field values are 1-255. The default value is 5.

Shared Secret – Enter the default authentication and encryption key for
communication between the device and the server.
Click Add to add the entry to the table.
In the list, you can click Modify to modify an entry or click Delete or delete the entry.
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, click Save Settings to Flash,
then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.