VARIJIG
-6-
ASSEMBLY & ADJUSTMENT
The T-nuts are held by the silver screws onto the
corner bracket, these will need to be
removed and the T-nut slid into
the slot in the extrusion
below the scale.
Adjustment
The black screws are used to lock the corner
bracket plates into the end of the extrusions.
Once they are fitted correctly they should not
need to be adjusted. The silver screws are the
screws that allow for adjustment of the frame.
By loosening the silver screws the extrusion can
be moved.
■
Place the ends of each extrusion with the
corner bracket fitted onto the bottom slot of
each extrusion, line up the T-nut and using
the silver screws join the corner bracket to
the T-slots in the extrusion.
■
Lay all parts onto a workbench in a square
with the metric scale side of the extrusions
towards the centre.
■
Slide the corner bracket assembly into the
open end of each extrusion, ensuring the
T-nuts align with the slots in the extrusion.
■
Slide T-nut down extrusion until corner
bracket assembly stops, then tighten the
black screws with a No. 2 Phillips
®
screwdriver.
Do not remove the T-nuts held by the
black screws onto the corner bracket.
Black
screw
Silver screw
Certain extrusions are fitted with end
caps for protection. These can be
temporarily removed to allow
accessories to be slid onto the
extrusion but should always be refitted.
The scale is self adhesive backed.
Only remove a 20mm section of the
self adhesive backing to ease
positioning of the scale.
MANU-VJS v3.0_MANU-VJS v3 18/06/2012 09:41 Page 6
