TREND T3-USA, Руководство по установке, использованию и обслуживанию

Страница: 10 / 22

-9-
How to Fit and Remove a Router Bit
Fitting Bits
■
Insert at least 3 /
4
of the shank length of the bit
(1) into the collet assembly (2).
■
Fit the 15mm A/F spanner (3) onto the flats
on the motor spindle to lock it while tightening
the collet nut, with the 17mm A/F spanner (4).
Do not use excessive force.
Removing Bits
■
Fit the 15mm A/F spanner onto the flats on
the motor spindle to lock it while undoing the
collet nut with the 17mm A/F spanner.
■
The bit should now slide out.
■
Each time you finish using a bit, remove it
and store it in a safe place.
■
A collet spring is fitted into the spindle behind
the collet to allow for easy collet change.
Do not tighten the collet
without a bit fitted.
Always use bits with
shanks which match the
diameter of the collet.
Do not use bits larger
than 1
3
⁄
16”
in diameter.
1
4
3
2
Correct Sequence for Fitting Collet,
Nut, Collet Spring and Bit
T3 - USA