SM/PRO
SM/PRO
G
U
ARAN
TE
E
SM/PRO
PRO
-14-
n
The router must be set so that the depth of cut
clears the bottom of the workpiece by 2mm.
n
Move the router baseplate to the left hand side and
engage the guide pin against the run in part of the
combs (set by the rear material guide stops).
n
The router speed should be set to no more
than 12,000 rpm.
n
After the first pass without a workpiece in the jig,
a small cut will be made in the spelch block, this
will be the exact cut every time the jig is used in
this setup. This means that the workpiece can be
marked to the correct length and this mark can be
aligned with the top of the cut on the spelch block,
making the jig a one cut solution.
n
If a higher speed is selected the cutter will burn the
workpiece rather than cut it and will also reduce the
cutter life considerably
n
Plunge the router to the correct depth and lock down
n
Turn on the router and once it has come up to
speed move the router from left to right keeping the
guide pin in contact with the combs.
Ensure component is clamped
securely in the jig before cutting.
n
The cutter will cut according to the comb set-up.
Continue to cut all the way to the right hand side
and into the sacrificial block.
n
Once the scribe is cut, turn off the router and let it
stop and release the lock.
n
The workpiece can now be removed by loosening
the material lock down bolt and sliding the
workpiece out of the jig.
There is no need to push hard against
the combs with the guide pin, let the
router do the work! If you push hard
you could distort the cut.
After use, store jig carefully.
Feed direction
Feed direction