COMBI 66
-15-
MAINTENANCE
Please use only Trend spare parts and
accessories
The jig has been designed to operate over
a long period of time with a minimum of
maintenance. Continual satisfactory operation
depends upon proper tool care and regular
cleaning.
Cleaning
n
Regularly clean the jig with a soft cloth.
Lubrication
n
Your jig requires no additional lubrication
Storage
n
After use store jig in its packaging. It can be
hung on wall hook
n
An accessory case is avaliable. Ref CASE/65
KWJ
650
Routing 35mm Circular Hinge
Recess
n
Mark the position of the hinge on the door.
The centre of the holes should be roughly
100mm from the top of the door to give the
required support, ensure this measurement is
as accurate as possible.
n
Position two pins in the holes marked in the
diagram right.
n
Position the jig as shown in the diagram with
the two pins pushed up against the edge of
the door, for a 5mm cut. Spacers can be used
between the edge of the worktop & pins to
adjust the hinge position.
n
Secure the jig with clamps. Checking the final
position of the jig is correct before starting the
cut.
n
Set the depth for 10mm.
n
Commence cutting of the recess making sure
to clean out the material in the centre of the
hole as well as round the edge.
n
Repeat operation increasing the cut by 1mm,
therefore setting the total depth for 11mm.
(This should be enough clearance for most
hinges. Adjust this measurement if you
require holes for thicker hinge heads).
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing as
waste.
Packaging should be sorted for environmental-
friendly recycling.
The product and its accessories at the end of their
life should be sorted for environmental friendly
recycling.
GUARANTEE
The jig carries a manufacturers guarantee in
accordance with the conditions on the enclosed
guarantee card.
100mm
5mm
-15-
Quick action
clamp here
=