Curved Peninsular
Insert the three location pins in the holes as
shown.
Locate the template on the worktop as
illustrated ensuring that location pins are
touching the worktop edge. Clamp into
position with quick action clamps.
When cutting the curved peninsular, hold the
router guide bush against the edge of the
template. Cut from left to right.
It is recommended that depth stops are used
and at least three or four cuts taken.
Postform edge
Location pins
Direction of
router travel
Cut with
laminate
down
Cut with
laminate
up
Postform edge
Postform edge
Postform edge
Postform edge
Peninsular
Peninsular End Cuts
Routing the Curved Peninsular
In order to prevent break out
of the laminate, rotation of the
cutter and feed direction of the
router must always be into the
postform edge of worktop.
KWJ
650
Quick action
clamp here
=
Routing 3/4” BSP Hole
Please check hole size is suitable for
mixer tap.
n
Mark position of hole for tap in worktop.
n
Place jig in position so that hole in jig is over
hole position.
n
Secure the jig with clamps.
n
Set the depth of cut for 8-10mm and plunge
cut. Repeat at different depths until hole is
routed.
After use, store jig carefully.
-14-