TREND JOINABOARD JOINTING JIG, Руководство пользователя, Страница: 7 / 12

JB/JIG
-7-
■
Both boards should rest against the underside
of the guide plate. Ensure both pieces of
wood are firmly pressed against the left hand
edge of the jig: one piece against the offset
stop, the other against the side of the jig
Setting-up the Jig for 8mm to 30mm
thick timber
■
Fit the Joinaboard jig over the ends of the two
boards.
plate
Setting-up the Jig for 31mm to 53mm
thick timber
■
If using timber between 31mm to 53mm, the
timber will need to be cut one piece at a time.
■
A 8mm thick backing piece will be needed for
one of the two cuts.
■
One piece of the joint will be cut with the
timber against the left hand edge of the offset
stop. The other piece will be cut with the
timber against the left hand edge of the jig,
with a 8mm packing piece placed behind the
timber to support it.
■
Ensure the wood rests against the underside
of the guide plate.
Offset stop
Offset stop Packing piece
1st cut
2nd cut
Offset strip
IMPORTANT!
For narrow timbers it may be
necessary to add a packing
piece to the edge of the timber.
This is to ensure the dovetail is
routed in the middle of the
timber.