TREND DJ300, Руководство пользователя

Страница: 5 / 25

DJ300
Assembly Instructions
■
To fit the four clamp bar set bolts (13), firstly
insert the half nut (20) into the embossed
slot(18) in the jig body (16). For the clamp
bar set bolts the two back top embossed
holes and the two front inner embossed slots
are used. Assembling one assembly at a time
fit the clamp bar set bolt (13) into the half nut
(20) from inside the jig body (16). Tighten
using the spanner enclosed. Repeat for the
remaining three bolt assemblies.
■
To fit the two template set bolts (19), firstly
insert the half nut (20) into the two outer front
embossed slots (21) in the jig body (16).
Screw the template set bolt (19) into the half
nut (20) from inside the jig body (16). Tighten
using the spanner enclosed. Repeat for the
other bolt assembly.
■
Fit the edge guides marked 1L (left-hand) &
1R (right-hand) to the dovetail body (16),
securing them with the edge guide washer
(12) and pan head screws (11) through the
fastening slots (15) and into the tapped holes
in the top of the body of the jig.
■
Screw the lock-nut (17) onto each of the
template bolts (19) on the front of the dovetail
body, followed by the knurled brass thumb
screw (14), keeping the knurled side to the
front. Adjust the lock-nuts so that they are
both 8mm from the jig body using the spanner
provided.
-5-
■
To install the clamping bars, identify front
clamping bar - short (3) and top clamping bar
- long (4).
■
Fit spring (5) onto the clamp bar set bolt (13)
and the fit clamp bar (3) or (4) on the set bolt
(13). Fit the nylon spacer (2) onto the set bolt
(13). (When using material, with a thickness
greater than 23mm, the nylon spacer must be
removed).
■
Thread the female clamp knob (1) onto the
set bolt (13). Fit both front and top clamp
bars in the same way.
■
Using a hammer, gently tap the two template
spring pin stops (19) into the holes in the
edge of the template (7). (This procedure is
also required for the 1/4” (6.35mm) template
accessory ref. DJ300/01).
■
Attach the aluminium template (7) to the
template brackets (9) with the four socket
head countersunk screws (8).
■
Slide the template by engaging the slots of
the template brackets (9) over the bolt (13).
Lightly tighten the knurled brass thumb
screws (14).
The jig will need to be mounted onto the
workbench or false work surface as shown on
page 8.
16
18 or 21
20 20
13 or 19
IMPORTANT!
Periodically check tightness of
all nuts and bolts.