TREND DJ300, Руководство пользователя

Страница: 17 / 25

DJ300
Routing the Drawer Front
■
Fit the correct guide bush and cutter.
Rout from right to left following the guide bush
in each of the slots.
The drawer front is now finished.
For drawer fronts with a different size of
rebate, adjust dimensions accordingly.
Routing the Side
■
This again is routed separately. Slide a scrap
piece of timber (1), the same thickness as the
side, under the top clamp. This is to prevent
tear-out.
Insert the side piece (2) under the front clamp
and align it with the scrap piece (1) and the
Try-square (3).
Clamp it in this position (4).
Rout as per normal lapped dovetail (see page
14 – Routing the Joint).
■
Remove the side piece and check the joint.
Use the chart on page 14 for adjusting the fit
if necessary.
-17-
4
2
1
3
Setting the depth of cut in the future
To ease setting up of the cutter height in the
future, rout a joint using the setting-up block in
the same position as a drawer front. Then use
this to accurately set the depth of cut of the
cutter in the future.
IMPORTANT!
Referring to the marking out of
the timber on page 10 please
place even numbers against the
left-hand edge guide and the
odd numbers against the right-
hand edge guide when routing.