AIRSHIELD
-14-
Sweatband
■
Pull apart to separate hook fasteners and
remove the sweatband from the headband.
Replacement of the sweatband is the reverse
of the above procedure. Ensure the foam
surface is fitted against the headband and the
slits are fully fitted over the headband.
Visor Overlay
■
Peel away visor protector and ensure visor
surface is clean.
■
Peel backing paper from adhesive strips on
replacement visor protector. Position centrally
onto visor surface, press down adhesive
strips and remove protective paper.
2
3
4
1
Headband
■
Pull apart to separate hook fasteners to
remove the sweatband from the headband.
■
Detach each end of the face seal from the
headband.
■
Unscrew and remove the knob (4). Push the
pivot pin (1) out through the cover washer (3),
torque washer (2) and headband. Repeat for
the opposite side to release the headband
and remove the torque washers (2).
■
Replacement of the headband is the reverse
of the above procedure. Ensure the torque
washers (2) are assembled onto the
headband correctly.
The knob assembly for the headband
is adjusted to relieve pressure to the
temples.
WARNING!
MANU-AIR v5.0 16/5/05 11:24 am Page 14
