TPS Hardware Specification and Installation
27
CAUTION!
Do not attach a ground wire to the ground screw on the DC power supply module. Attach the ground wire to the 2200T chassis DC
grounding screw holes (0.63-inch hole spacing) with #10 screws. The DC grounding screw holes are located in the rear of the
chassis.
The power supply LED is green when the module is powered and running normally.
When the DC power supply has been securely placed in the device, use the following procedure to connect power to the DC
power supply.
Procedure
1.
Locate the ground screw on the back of the chassis.
Refer to the following figure for the location.
2.
Attach a 12 AWG ground wire to the chassis ground strap mounting.
The wire should be crimped with a ring lug.
3.
Locate the power input terminal block on the back of the module.
4.
Attach the 12 AWG DC power wires to the power input terminal block labeled -48V and RTN.
The power wires should be crimped with lug spades to ensure a secure connection.
5.
Connect the other side of the power cable to the SELV power source.
The power source should meet the following requirements:
•
Voltage: -40 to -60 V
•
24 to 16 Amps
•
SELV
Содержание TPS 2200T
Страница 1: ......
