USB-ISP programmer
Installation:
Please download the *inf file for the ISP-programmer driver.
Please download the last driver “AVR-ISP-Driver” for the ISP-Programmer on the seller’s website
www.diamex.de
. Go to the download section where you can also download a product description.
“Stange ISP Prog” for Win XP
“Dx_ISP.inf” Vista or Win2000
“avr-isp.inf” for Win7
For Windows 8 please read the information at the end of the description.
Store the *inf file on the hard drive or in a search path. Connect the programmer and run (automatic)
the driver assistant.
During the installation Windows will ask for a driver. The windows driver will be used which will be
communicated to the system by the special Stange_ISP_Prog.inf file.
In the next dialogue specify where the .inf file is located.
ISP-SPI-speed:
Due to the USB connection minor deviating ISP-frequencies may be caused towards a STK500.
STK500
ISP-Prog
921.6kHz
1MHz
230.4kHz
250kHz
57.6kHz
62.5kHz
28.8kHz
28.2kHz
4kHz
4kHz
603Hz
779Hz
LEDs
-USB-LED: flashes during USB activity
-Target LED: shut off in idle, flashes during target access
Functions
-FLASH, EEPROM, Fusebits, writing Lockbits, reading, chip erase, reading OSCCAL register
Log
-STK500v2
Software assisted
-AVR Studio (COM1…COM9) Version 4/5/6
-AVRDUDE
-Bascom with setup-options-programmer=STK500:
C:/Programms/Atmel/AVR Tools/STK500/stk500.exe (STK500 native driver) and installed AVR Studio
4/5/6
Switch position for normal programming in user’s switching= both switch OFF
If voltage supply of the target is needed.
