For a single AVR controller only without own switching 5V are required (for example Diamex program
adapter/pivot lever) 1=on 2=on
General: 3.3V max. 120mA, 5V 150-500mA. Depending on which computer is used.
Switch 1 off= target voltage off/on, switch 2 off= 3.3V / on=5.0V. The programmer doesn’t need a
power supply from the target for the programming operation.
Equipment
-ISP programmer in a stick case
-USB 2.0
-SPI connection cable 6 pin 15cm (Atmel standard – check the upper drawing) 15cm
-manual
Supports the following controller:
Classic
AT90S1200, AT90S2313, AT90S2333, AT90S2343, AT90S4414, AT90S4433, AT90S4434, AT90S8515,
AT90S8535
Tiny
ATtiny12, ATtiny13, ATtiny15, ATtiny2313, ATtiny24, ATtiny25, ATtiny26, ATtiny44, ATtiny45,
ATtiny85, ATtiny86, ATtiny261, ATtiny461, ATtiny861
Mega
ATmega88, ATmega103, ATmega128, ATmega1280, ATmega1281, ATmega16, ATmega161,
ATmega162, ATmega163, ATmega164, ATmega168, ATmega169, ATmega2560, ATmega2561,
ATmega32, ATmega324, ATmega325, ATmega3250, ATmega329x, ATmega64, ATmega640,
ATmega644, ATmega645, ATmega6450, ATmega649x, ATmega8, ATmega8515. ATmega8535
Further
AT90CAN128, AT90PWM2, AT90PWM3, AT90PWM3B, AT90USB162, AT90USB646, AT90USB647,
AT90USB1286, AT90USB1287
and all ATMEGA processors, which support the ISP-programmer interface. Also Arduino boards are
supported.
Driver installation for Windows 8:
The Windows 7 driver works also on Windows 8. The following report appears:
“The third party *inf file does not contain digital signature information”
Charme set up on/off - hold shift and click on restart or
Charme set up / More PC settings / General / Advanced start up then troubleshot /advanced options
start set up. The computer will restart and shows a menu please press key 7.
Disable driver signature – Now the driver can be installed.
For any questions please do not hesitate to contact us:
/
Driver installation for Windows 8:
The Windows 7 driver works also on Windows 8. The following report appears:
“The third party *inf file does not contain digital signature information”
Charme set up on/off - hold shift and click on restart
or
Charme set up / More PC settings / General / Advanced start up
then
troubleshot /advanced options
start set up. The computer will restart and shows a menu please press key 7.
Disable driver signature – Now the driver can be installed.
