Trelawny A45, Руководство по эксплуатации и обслуживанию

Страница: 8 / 20

Release the levers that hold the
motor head
.
MAINTENANCE
Lift the motor head by means of the
handles provided and rest this on a
support bench, take not to damage
the power cable.
Remove from underneath the
vacuum cleaner the R - Clip (A) and
Cage Pivot Pin (B) that fasten the
filter to the Shaking Lever.
Lift out the filter complete with its
support cage.
Unscrew the clamp and remove the
support ring with seal.
Undo the tied knots from inside (A)
and the underside, then remove the
pocket filter.
Fit the new filter, put everything back
together carefully securing all ties.
Caution, hand crushing hazard.
The Hopper locking operation must
be performed by one person only,
who must lower the lever with both
hands to lock the Hopper in position.
Replacing the filters
To replace the filters, proceed as
follows:
Turn off the vacuum cleaner by
pressing down the motor STOP
switches.
Disconnect the vacuum cleaner plug
from the power socket.
Ensure braked front wheel is locked.
Lift the lever that locks the Hopper.
Remove the ENDLESSBAG Hopper.
Important
All material trapped and contained
within the filter must be disposed of
according the local legislation
NOTE:
Do not place hands on sides of
ENDLESSBAG Hopper near the
guide pins while re - installing.
Perform the ENDLESSBAG
Hopper locking operation by
means of the lever located on the
front, USE BOTH HANDS !!
A
B
A
DOWN
UP