Trek DOMANE SLR 2017, Руководство по обслуживанию

Страница: 8 / 28

1 INSTALLING THE ADJUSTABLE REAR ISOSPEED DECOUPLER AND SEATMAST
Installing the seatmast
1.
Apply grease to the bore holes of the seatmast
and to the bore holes on the frame.
2.
Insert the IsoSpeed axle into the seatmast
as shown.
3.
Place a bearing and then a pivot locating washer
onto the pivot bolt. Repeat so you will have two
bolt assemblies. If you are reusing a bolt, clean
the threads and apply Loctite 242.
NOTE
The pivot locating washer is installed between the
IsoSpeed seatmast and the IsoSpeed bearing.
4.
Align the bore holes in the seatmast with the
opening in the frame.
5.
Pass one of the pivot bolt assemblies from Step 3
through the bore hole and thread it into the
IsoSpeed axle.
6.
Insert a 6 mm Allen key into the non-drive side of
the IsoSpeed axle to hold it steady (6a). Insert a
5 mm Allen key into the pivot bolt and turn it to
engage the threads (6b).
Do not fully tighten.
mm
5
mm
6
6a
6b
GREASE
4