Tredy TD-2600, Инструкция по эксплуатации

Страница: 4 / 10

Water is released into the water tank when the Float Paddle engages the Plunger at the bottom
of the housing. A Nebulizer vibrates at ultrasonic frequency, breaking the water into a fine mist.
The mist is quietly propelled by a fan up a vertical Fogging cylinder to the Mist Outlet where the
cool, visible mist enters the room. This humidifier will automatically shut off when the water level
is low.
1. SET UP YOUR HUMIDIFIER
①Remove packaging materials. Put the water tank on the housing.
②Remove twist tie and extend power cord. Place on a firm, level, water resistant surface a
minimum of 12 inches (30 cm) from walls.
2. SFILLING OR RERILLING WATER TANK
This humidifier holds a maximum of 1.31 gallons (5 liters) of water.
①Take the tank cover out of the water tank.
②Pour pure water or clean from a pitcher or jug directly into water tank. Or take the water tank
out from humidifier then pour water from tap, and place correctly on housing.
③Fill to the MAX line marked on the inside of the tank.
④Place tank cover correctly on the tank, the nozzle fits with the mist chamber.
NOTE : Water temperature shall not surpass 40 Celsius degree.Should not pour water into the
mist chamber when pour water into water tank in order to avoid water flowing out from the air
outlet.The water tank should be carried using two hands when pour from tap; one hand on the
one side of the tank and other hand supporting the bottom of the tank. Carry water tank back
to humidifier.Replace the full Tank on the housing.
3. Product introduction
Product component structure
Product installation and use
2
MAX
Mist Outlet
Tank Cover
Water Tank
Housing cover
(Max. Water-Level
in housing)
Power Cord
Power Knob
Max Water Line
Fogging cylinder
Float Paddle
Housing
Air Outlet
Instruction Ligh
MAX