![Treatlite Active 120 mW Скачать руководство пользователя страница 13](http://html1.mh-extra.com/html/treatlite/active-120-mw/active-120-mw_user-manual_1154866013.webp)
12
13
6. Contact information
Address:
Contact:
Treatlite Corporation AB
Telephone: +46 (0) 455 30 95 30
Roparebergsv. 14
E-mail: [email protected]
371 42 Karlskrona
Web: www.treatlite.se
SWEDEN
7. Installation
7.1 Installing and changing batteries
1. Undo the screw on the battery lid with a screwdriver.
2. Open the lid and remove the battery module.
3. Install new batteries. Note + (plus) and – (minus) for the batteries in the battery module.
4. Refit the battery module and battery lid. Finally, fasten the screw.
8. Functions
8.1 Starting the laser
1. Press the Start button.
2. One acoustic signal and a blue light on the Start button indicate that the laser light has been activated.
3. The laser light is activated for about 24 seconds and then stops automatically which is indicated by two short
acoustic signals and the blue light turning off.
8.2 Battery indicator
When the battery is starting to run low, this is indicated at the start of treatment by Treatlite Active repeating
an acoustic and light signal for 8 seconds. No laser light is activated during this signal. This is repeated each
time the product is started until the batteries are replaced. The same signal is used if incorrect batteries
(e.g. voltage too high) are used.
8.3 Dose indicator
Treatlite Active has a built-in dosage system that tells the user when a correct dose has been given (approx.
24 seconds). This is done with an acoustic and light signal. One press equals one dose. See the treatment
suggestions under point 11 for a suitable number of doses.
9. Maintenance
9.1 Cleaning
Use moist towelettes or hand disinfectant for skin to clean the unit carefully. Wipe the outside only.
If fluid penetrates into the electronics the warrenty is not valid.
English
Содержание Active 120 mW
Страница 1: ...SE Bruksanvisning GB User Guide ...
Страница 22: ...22 ...