Treasure Garden AKZ, Руководство по сборке и эксплуатации

Страница: 10 / 12

2 9
REQUIRED FOR ASSEMBLY:
• 200 lbs. playground sand (not included).
NOTE: Do not put or allow sand into the center of the base shell.
S A F E T Y P R E C A U T I O N S :
• Close the umbrella in windy conditions or when a storm approaches.
Never allow the umbrella to flap in the wind; this could damage the canopy.
• Do not leave open umbrella unattended. If damage occurs, this is not covered
by the warranty.
• When adjusting the umbrella, make sure that no person(s) or item(s) are close to the
umbrella. This is important to prevent injury or material damage.
C A R E A N D M A I N T E N A N C E :
• When not in use, close and cover umbrella with a protective cover (included).
• Allow a wet canopy to dry opened up.
• If necessary, clean the fabric with lukewarm water, mild detergent, and a sponge.
• Wipe sliding marks on the aluminum poles with a damp cloth.
Winter Storage:
• Store in a dry, protective place.
• Any visible defects must be repaired by a professional.
After the Winter:
• Areas subject to turning and sliding can be treated with a non-staining lubricant spray
(silicone-based).
• Check the condition and function of the umbrella. Any defects must be repaired by a
professional.
CAUTION: Fully assembled, the AKZ/AKZSQ umbrella weighs over 300 lbs. Moving
the umbrella fully assembled will increase the risk of damage to your umbrella and
can cause serious injury.
We recommend a two-person team to assemble or
disassemble the umbrella.
IMPORTANT: Prior to assembly it is important to decide on the location of the AKZ umbrella.
The umbrella measures approximately 10 ft. in height and 13 ft. in width.
• Allow ample height to avoid damage to your umbrella during assembly and usage.
• Choose a location that is level and sturdy.
• Avoid any sloping or soft ground cover.
• Consider a location that will maximize the umbrella’s rotating swivel function. Placing
the AKZ between two entertaining areas is ideal.
NOTE: Some parts may be included in the styrofoam packaging. DO NOT discard any
packaging or box until assembly is complete.
1 Base Shell 1
2 Base L i d 1
3 Steel Wrench 1
4 Inverte d Base Stem 1
5 Mounting P late 1
6 P laygroun d San d (not inclu d e d ) 200 lbs .
7 L arge Hexagon Wrench 1
8 AK Z Main Frame 1
9 Crank L ift Han d le 1
10 Small Hexagon Wrench 1
11 Hub Bolts 5
12 P late Bolts 4
13 Washers 5
AKZ/AKZSQ PART LIST
P art Descri p tion Qty .