Sintel-3 VM Instruction Manual
ENGLISH
2.0. Connections
1 Telephone line input 1 8 NORMALLY CLOSED relay output
2 Telephone ground line input 9 Input command for channel 1
3 Telephone line input 2 10 Input command for channel 2
4 Output to connect normal telephone 11 Input command for channel 3
5 Output to connect normal telephone 12 Input command for dialler inhibition
6 COMMON relay input 13 Negative power input (-12Vdc.)
7 NORMALLY OPEN relay output 14 Positive power input (+12Vdc.)
1 2 3 4 5 6 7 8 9 10 11 12 13 14
LINE TEL. C NO NC L1 L2 L3 12V
RELE’
IN
IB
.
+
Microphone
3.0. Programming
Before powering up the SINTEL-3VM, we suggest that the unit be reset.
To resent the unit, you must press any button on the keypad and keep it pressed. Power up the unit and a beep
will be heard. After a few seconds another beep will be heard. This second beep will confirm that the reset has
been successful. Release the keypad button and another 2 beeps will be heard. This will indicate that the
SINTEL-3VM is ready to function. Note, however, that if there are voice messages programmed in the unit the reset
procedure will not cancel these messages. To enter the programming mode one must digit the factory technical
code 555555 or the user code 123456. In case of error the voice menu will clearly indicate it by saying PIN
ERROR. You will note that on every key pressed a beep will be emitted to confirm command reception.
If you input the Technical code, the following functions will start-up:
- By pressing the symbol ( * ) you may exit the menu.
- You may memorize the telephone numbers.
- Listen to the telephone numbers memorized.
- Change the technical code.
- Record the messages
- Playback the memorized messages
- Trigger the alarm but you must select one of the following:
Input a positive contact
Remove a positive contact
Input a negative contact
Remove a negative contact
If you input the user code the following functions will be come will start-up.
- Exit the menu by pressing the ( * ) key.
- Memorize the telephone numbers.
- Listen to the telephone numbers memorized.
- Change the user code.
- Playback of the memorized messages.
Once you have entered into the programming mode, follow the guided menu instructions.
1.0. General Description
The Sintel-3 VM is a voice dialler capable of memorizing 5 telephone numbers on 3 alarm trigger channels. It is
possible to memorize, on each channel 1 message for a total of 3 messages, and activate from remote a dry con-
tact relay. The voice guided menu offers both installer and end user a form of easy programming.
