TRBOnet Swift A200, Руководство пользователя

Страница: 19 / 32

16 TRBOnet Swift A200 – User Manual
3.2 Non-MOTOTRBO Mode
To prepare TRBOnet Swift A200 for operation in the non-MOTOTRBO mode, follow
the steps in Table 7.
Table 7: High-level steps to prepare TRBOnet Swift A200 for operation in the non-MOTOTRBO mode
# Step Refer to:
1 Assemble the service cable. 3.2.1 Assembling the Service Cable (page
16)
2 Update the firmware and configure your A200
gateway.
3.2.2 Configuring the A200 (page 18)
3 Update the configuration settings of the
radio.
3.2.3 Configuring the Radio (page 20)
4 Connect your A200 gateway to the radio and
to the LAN.
3.2.4 Connecting the Radio (page 20)
5 Connect your A200 gateway to the power
supply.
3.3 Power Supply (page 20)
6 Power up the connected radio.
3.2.1 Assembling the Service Cable
The A200 gateway and a non-MOTOTRBO radio are connected using the service cable
and the audio cable. To assemble the service cable, use a Micro-Fit connector plug, a
wire kit, and a radio connector plug.
Note: The radio connector plug is not included in the delivery kit. Contact the
manufacturer of your radio or a sales representative to get the plug compatible
with the service connector of your radio.
To assemble the service cable:
Connect the wires to the Micro-Fit plug and to the radio connector plug to
implement the following required links:
Table 8: Service cable – required links
Function Micro-Fit plug Radio connector plug
PTT Any input pin (Pin 1 – Pin 7) Use pins as advised in the
documentation of the radio.
CSQ Detect Any output pin (Pin 1 – Pin 6, Pin 8)
Ground GND pin (black wire)
Note: The Micro-Fit connector pins are described in section 2.7 Connectors (page 6).
Connect the wires of the audio cable (provided in the delivery kit) to the radio
connector plug. Implement the following required links: