20
TRBOnet Swift A200 – User Manual
Figure 14: Configuring the audio signal
To save the configuration to your A200 gateway, click the
Write
button, or
open the
Device
menu and click
Write
.
3.2.3
Configuring the Radio
After you have assembled the service cable, configure your radio to use the radio
connector pins that are coupled with the pins of the A200 gateway. Use the radio
programming software provided by the manufacturer of the radio.
Program the GPIO pins of your radio as described in the documentation supplied by
the manufacturer of the radio.
3.2.4
Connecting the Radio
When the service cable is finished and pins are configured on the radio and on the
A200 gateway accordingly, connect your A200 gateway to the radio and to external
hardware (if necessary).
Note: Before connecting the A200 gateway, make sure that the radio is powered off
and that the A200 gateway and all external hardware (if any to be connected)
is disconnected from the power supply.
To connect the A200 gateway to the radio and to external hardware:
Connect the Micro-Fit plug of the service cable to the Micro-Fit connector on
the rear panel of the A200 gateway.
Connect the audio cable to the audio input and audio output on the rear panel
of the A200 gateway.
Connect the other end of the service cable to the service jack of the radio.
If required, connect the wires of the service cable to external hardware.
When all connections are done, connect the A200 gateway and external hardware to
the power supply. Then power up the radio.
3.3
Power Supply
This section describes how to connect the A200 gateway to the source of +12V DC
(recommended) or to an AC power supply.
