TRAYNOR BASS MASTER
_________________________
YBA-1 TRIBUTE
________________
GENERAL INSTRUCTIONS
1.
Before turning on the amplifier, connect a speaker cable from one of
the rear speaker jacks to a speaker cabinet.
2.
Use the impedance switch to match the impedance of the 4 or 8 ohm
speaker cabinet being used.
3.
Rotate the rear panel Attenuator switch to the desired output level.
4.
Plug the power cord into a wall outlet.
5.
With the front panel OPERATE switch set to the Standby position
(downward), flip the rear panel A.C. On switch up into the on position.
6.
Leave the unit in standby mode while the tubes warm up for about 1
minute and then flip the front panel OPERATE switch into the operate
position. The Bass Master YBA-1 Tribute amp is now ready to use!
CAUTION:
REPLACE WITH
SAME TYPE FUSE AND RATING
ATTENTION:
UTILISER UN FUSIBLE DE
RECHANGE DE MEME TYPE ET CALIBRE
MODEL TYPE: YS1105
A-Z1530R / 1v0
DISCONNECT POWER
BEFORE SERVICING!
DEBRANCHER L’APPEREIL AVANT
D’ENLEVER LES COUVERCLES!
THIS UNIT MUST BE GROUNDED!
CET APPAREIL DOIT ETRE MIS Á TERRE!
Bass Master
I
I
+
II
I
II
