The Traxxas TQ Radio System
17
Setup Programming
1.
Place the boat on a boat stand. Always make sure that objects
and fingers are clear of the props. The motors will not run
during programming.
2.
Connect a fully charged battery pack to the ESC.
3.
Turn on the transmitter with the throttle at neutral.
4.
Turn on the marine ESC with the
external switch. The LED will turn
solid green. (Note: If the throttle is
not at neutral, the LED will turn off
after one second. )
5.
Press and hold the ESC set button
until the LED turns red; then release
the set button. The LED will turn off
after 3 seconds.
6.
When the red
LED blinks ONCE,
pull the throttle
trigger to the full
throttle position
and hold it there.
7.
After 3 seconds,
when the red LED
blinks TWICE,
push the throttle
trigger to the full
reverse/brake
and hold it there.
8.
The LED will turn solid GREEN,
indicating the programming is
complete.
Profile Programming
The speed control is factory set to Profile #1 (forward with 25%
reverse). To disable the reverse (Profile #3), or to allow full
reverse (Profile #2), follow these steps. The speed control should
be connected to the receiver and the transmitter adjusted as
described on page 16.
Profile Description
Profile #1:
100% forward, 25% reverse.
Profile #2:
100% forward, 100% reverse.
Profile #3:
100% forward only, no reverse.
Profile #1
(100% forward, 25% reverse)
The red LED will blink ONCE, blink TWICE, and then turn solid
green indicating the profile programming is complete.
Twice
Once
Twice
Once
Twice
Once
Twice
Once
Twice
Once
Twice
Once
Twice
Once
Turn on the transmitter with the throttle
at neutral. Press and hold the set button
until the LED turns red, then turns off.
Release the set button.
Keep the throttle
at neutral.
Twice
Once
Twice
Once
Twice
Once
1
2
3
4
5
6
Using an Aftermarket
Transmitter.
The following instructions
are provided as reference
only for those who are using
an aftermarket transmitter in
place of their factory TQ.
1. Set the High ATV or
EPA to the maximum
setting. This is the
amount of servo throw
at full throttle.
2. Set the Low ATV,
EPA, or ATL to the
maximum setting. This
is the amount of servo
throw at full reverse.
3. Set the Exponential to
the zero setting. This
adjusts the throttle
channel linearity.
4. Set the Throttle Channel
Trim to the middle
setting. This adjusts the
neutral position and
increases or decreases the
amount of coast braking.
5. Set the Throttle Channel
Reversing Switch to either
position. Do not change
the switch position after
programming.
6. Set the Trigger Throw
Adjustment to 70%
throttle and 30%
brake throw.
Содержание Villain 1506
Страница 1: ......
