Slayer
•
7
Quick Start: Getting up to Speed
The following guide is an overview of the procedures for getting your Slayer running, from opening the box to breaking in and tuning your
engine. Refer to the pages indicated for details on each step. Look for the Quick Start logo on the bottom corners of Quick Start pages.
1. Read the safety precautions on page 4
10. Range test the radio system • See page 15
For your own safety, understand where carelessness and misuse could
lead to personal injury.
Follow this procedure to make sure your radio system works properly at
a distance and that there is no interference from outside sources.
2. Charge the EZ-Start battery pack • See page 24
11. Fill the fuel tank • See page 21
The EZ-Start requires a fully charged 7.2-volt battery
pack (sold separately).
Use your fuel-dispensing bottle to fill the tank.
3. Install the receiver batteries • See page 11
12. Connect the EZ-Start to the model • See page 24
Slayer requires 4 AA alkaline or rechargeable batteries
for the receiver (sold separately).
Learn the proper way to use the EZ-Start electric starting system.
4. Install the antenna • See page 12.
13. Start the engine • See page 26
Use the antenna nut wrench to install the antenna mast in Slayer.
Learn to use the correct starting procedure for your TRX 3.3.
5. Decal and Install the body • See page 8
14. Break-in your engine • See page 26
You will need to use the body during break in, so it’s best to apply any
additional decals before you use the body.
Follow the break-in instructions exactly to ensure the
best-performing, longest-lasting engine.
6. Install batteries in the transmitter • See page 11
15. Tune your engine • See page 28
Slayer requires 8 AA alkaline or rechargeable batteries
for the transmitter (sold separately).
Learn how to set the fuel mixture needles for optimum
engine performance.
7. Install the EZ-Start battery • See page 24
16. Drive your Slayer • See page 31
Install and connect a charged 7.2-volt battery pack in
the EZ-Start controller.
Learn to use the two-speed function on your truck, along
with important driving precautions.
8. Turn on the radio system • See page 14
17. Maintaining your Truck • See pages 38-39
Make a habit of turning the transmitter on first, and off last.
Follow these critical steps to maintain the performance of your
Slayer and keep it in excellent running condition.
9. Check servo operation • See page 15
Make sure the throttle, shifting, and steering servos are
working correctly.
The Quick Start Guide is
not intended to replace the
full operating instructions
available in this manual.
Please read this entire
manual for complete
instructions on the proper
use and maintenance of
your Slayer.
Look for the Quick Start
logo at the bottom of
Quick Start pages.
