SLASH • 7
QUICK START: GETTING UP TO SPEED
The following guide is an overview of the procedures for getting your model running. Look for the Quick Start logo on the bottom
corners of Quick Start pages.
1. Read the safety precautions on pages 3-4
7. Check servo operation • See page 14
For your own safety, understand where carelessness and misuse
could lead to personal injury.
Make sure the steering servo is working correctly.
2. Charge the battery pack • See page 11
8. Range test the radio system • See page 14
Fully charge the included battery pack. Charge your battery now so
it will be ready when you finish the other setup procedures.
Follow this procedure to make sure your radio system works properly
at a distance and that there is no interference from outside sources.
3. Install the antenna • See page 15
9. Detail your model • See page 8
The receiver antenna and antenna tube must be properly installed
before operating your model.
Apply other decals if desired.
4. Install batteries in the transmitter • See page 11
10. Turn on the Sound Control Module • See page 18
The transmitter requires 4 AA alkaline or rechargeable batteries
(sold separately).
5. Install battery pack in the model • See page 12
11. Drive your model • See page 19
Your model requires a fully charged battery pack (included).
Driving tips and adjustments for your model.
6. Turn on the radio system • See page 13
12. Maintaining your model • See page 24
Make a habit of turning the transmitter on first and off last.
Follow these critical steps to maintain the performance
of your model and keep it in excellent running condition.
The Quick Start Guide is
not intended to replace the
full operating instructions
available in this manual.
Please read this entire
manual for complete
instructions on the proper
use and maintenance of
your model.
Look for the Quick Start
logo at the bottom of
Quick Start pages.
