www.traxontechnologies.com
©2019 TRAXON TECHNOLOGIES - AN OSRAM BUSINESS. ALL RIGHTS RESERVED. TRAXON™, TX CONNECT®, ARE TRADEMARKS OF TRAXON TECHNOLOGIES. U.S. PATENTS, E.U.
PATENTS, JAPAN PATENTS, OTHER PATENTS PENDING. SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
Installation Guide
12/19 V2.0
16 of 23
2.3.2
Mounting Allegro Dot M/L
1. Allegro Dot M/L must be mounted without any stress induced at the boundary area of
the cable and Allegro Dot.
2. Allegro Dots MUST be mounted to the installation surface via the mounting holes, either
by screw or cable tie.
FIG.15: Mounting the Allegro Dot M/L
(M3 Screws not included)
Suggested alternative method
if M3 screws are not viable
(Cable ties not included)
(M3 Screws not included)
Suggested alternative method
if M3 screws are not viable
(Cable ties not included)
3. Cable segment must not be bent below 20mm from the housing of the Allegro Dot M/L
and cable overmold (Minimum Bending Length).
4. Secure the cables between Allegro Dot M/L (every 500mm, using cable tie) and create a
small clearance beneath the cable (see below diagram). Ensure no damage is generated
on the cable.
FIG.16: Securing the cable
Observe clearance
Cable tie
Mounting surface