www.traxontechnologies.com
©2019 TRAXON TECHNOLOGIES - AN OSRAM BUSINESS. ALL RIGHTS RESERVED. TRAXON™, TX CONNECT®, ARE TRADEMARKS OF TRAXON TECHNOLOGIES. U.S. PATENTS, E.U.
PATENTS, JAPAN PATENTS, OTHER PATENTS PENDING. SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
Installation Guide
06/19 V1.1
8 of 21
www.traxontechnologies.com
©2019 TRAXON TECHNOLOGIES - AN OSRAM BUSINESS. ALL RIGHTS RESERVED. TRAXON™, TX CONNECT®, ARE TRADEMARKS OF TRAXON TECHNOLOGIES. U.S. PATENTS, E.U.
PATENTS, JAPAN PATENTS, OTHER PATENTS PENDING. SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
Installation Guide
06/19 V1.1
9 of 21
Connector should be properly connected with cable connectors and the DATA OUT of the
last Pixel Distributor should be covered by its Waterproof End Cap to ensure IP66/67 rating.
FIG.8: Seal last Pixel Distributor with Waterproof End Cap
Waterproof End Cap
Tightening Torque
0.49~0.69Nm (5~7kgfcm)
2.2.2
Handling The Allegro Dot M/L String
When transporting or preparing the Allegro Dot M/L string, please handle with care. To reduce
stress on cables, carry by the Allegro Dots and not the cable during transit.
FIG.9: Correct way of handling Allegro Dot M/L String
Allow slack on cable to
reduce stress
Allow slack on cable to
reduce stress
2. INSTALLATION
2.1 Points To Consider
Plan your installation before mounting any luminaires. The following should be considered for
a successful installation.
•
Weather conditions and ambient temperature of installation site.
•
Appropriate cable lengths
•
Adequate space for better heat dissipation (150mm apart) of LED Engines (see “2.3 On-
Site Installation” on page 12).
•
Appropriate anchor bolts where necessary to secure the Allegro Dot M/L.
•
The number of Allegro Dot M/L and appropriate Pixel Distributors with LED Engines.
•
Controller to be used to control the Allegro Dot M/L.
2.2 Pre-Installation Checks
2.2.1
Installation Checklist
1. Prepare cables and all necessary accessories.
2. Perform functional check of Allegro Dot M/L.
3. Ensure the DATA OUT connector on all Pixel Distributors are covered by the Waterproof
End Cap after testing (see FIG.8 on page 9). Keep Waterproof End Caps safe for
reuse.
4. Ensure all pre-installation checks laid out below have been followed.
5. Mount the Allegro Dot M/L on-site. If the installation is to be left uncompleted overnight,
place all non-connected LED Engines, Pixel Distributors and Allegro Dot M/L in an indoor
environment.
Ensure all the Connection Cables, Allegro Dot M/L with LED Engines and Pixel Distributors are
initially stored in a dry area to guarantee the complete sealing of the system from water before
installation.
