Accent Light, Type 2A
(SKU 94400111)
Page 3 of 5
3/28/07
© Travis Industries, Inc.
Tree of Life / Berkshire Installation
NOTE:
The bulb is shipped separately. Do not touch the bulb – oil or other residue left on the bulb may lead to
premature bulb failure. Use a cloth or paper towel to handle the bulb.
1
Modify the accent light assembly as shown in the illustration below.
Loosen these nuts
and slide the light
receptacle out (take
care to not touch the
halogen bulb)
Re-attach the
receptacle to the
opposite side.
Remove the screw
that holds the accent
light bracket in place.
Re-attach it in the
second hole from the
top. This lowers the
accent light for proper
light placement.
Accent Light Bracket
Bend this tab upwards
to a 90° angle.
a
b
c
2
Remove the burner from the stove (see owner’s manual for details). Install the accent light assembly as
shown in the illustration below.
AA
AA
AA
A
A
A
Remove this screw on the firebox floor.
Position the accent light assembly in the
same location, and re-attach the screw to
secure the accent light assembly.
NOTE: This insulation protects the wiring - it
may be compressed if necessary.
Remove and discard the cover
plate (accessed from below).
a
b
NOTE: The accent light requires the right side access hole. If
this hole is being used for the thermodisk for optional blower,
switch the thermodisk to the mounting position on the left side.
NOTE: To prevent heat-damage to the wires,
make sure this wires are routed along the
floor of the firebox, away from the burner.
Route the wires from the
accent light through gasket
and hole. Attach the accent
light cover plate (with
grommet) to the firebox floor
with the screws removed in
step “b”. Pull the excess
wire through the grommet,
towards the front of the stove
(this helps prevent the wire
from contacting the burner).
c
AAAAAA
AAAAAA
AAAAAA
AAAAAA
AAAAAA
AAAAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
