Accent Light, Type 2A
(SKU 94400111)
Page 2 of 5
3/28/07
© Travis Industries, Inc.
3
Attach the rheostat assembly and wiring harness as shown below.
AA
AA
AA
A
Disconnect the molex connector
leading to the power cord.
Attach the two molex connectors on the
rheostat wiring harness to the power cord and
the molex connector on the appliance.
Attach the quick-
connect from the
accent light to the
quick-connect on the
rheostat wiring
harness.
Use the included wire nut to connect
the wire leading from the rheostat to
the remaining wire leading from the
accent light.
Slide the rheostat assembly into
place and secure with the
included nuts.
d
e
Make sure all wiring does not contact the
firebox or blower (use wireties if necessary).
a
b
NOTE: Make sure the
grounding wire remains
attached (if applicable).
AAAAAAAAA
AAAAAAAAA
AAAAAAAAA
AAAAAAAAA
AAAAAAAAA
AAAAAAAAA
AAAAAAAAA
AAAAAAAAA
AAAAAAAAA
AAAAAAAAA
AAAAAAAAA
c
4
Install the bulb into the accent light (take care to not touch the bulb).
5
Restore the firebox to the correct configuration (replace the burners, etc.).
