ProBuilder 36/42CF Blower Kit (MV / GSB2)
SKU# 99000199
Page 6 of 8
17602032 - Printed 8/20/18
© Travis Industries, Inc.
7. Guide the remaining wire harness into the fireplace and direct it toward the right front corner of the fireplace.
Insert the blower assemblies into the cavity. The rubber grommets fit over the studs and then use (2) of the
8-32 KEPS nuts to secure the blower assemblies (do not overtighten). The blower assemblies should be
oriented so the motors are in the middle (see picture below).
8. The portion of the installation that is performed through the rear access panel is now complete. Reinstall
the cover plate and screws removed in step 2.
9. Detach the dashboard from the front of the fireplace and set the dashboard face down (do not disconnect
any wires). Set the (4) screws aside for reinstallation.
Motors face to
the inside
Place grommet
over stud
Place grommet
over stud
Secure with nut
Repeat with left blower
