616 EmberGlo™ (EG) Insert - Cheat Sheet
Page 2 of 2
17602083
Printed 8/21/19
HAVE YOUR ACCESSORIES ON HAND WHEN INSTALLING THIS INSERT
This insert requires the following accessories:
Media Kit (logs/stones)
Firebacks
Surround Panels
Face
These accessories are required to ensure correct and safe operation. Do not operate the appliance
without the firebacks in place.
ORDER OF INSTALLATION
When setting up the insert, you will need to follow a specific order of installation to optimize
installation time. Failure to have all of the accessories available at the time of installation will delay
installation and may lead to unnecessary disassembly of components.
1. Run gas line to the fireplace
2. Remove the glass frame.
3. Run vent through fireplace chimney. On larger fireplaces, the vent connector may be left in place.
For smaller fireplaces, remove the vent connector. See “Vent Connector Removal and Installation”
for details.
INSTALL THE LIGHT SHIELD (ALL FACES EXCEPT SHADOWBOX).
The light shield
(shipped with the face) prevents light from exiting the upper grill area. Install this prior to
placing the insert.
4. Place insert into position and attach the gas line and vent.
5. Remove the burner.
NOTE
: If using propane (LP), convert the appliance at this time.
6. Install the firebacks.
7. Replace the burner.
8. Install the media (logs, stones - see instructions included with the media).
9. Install the surround panel (see instructions included with surround panel).
10. Replace the glass.
11. Install the face (see instructions included with the face).
12. Follow the instructions under “Finalizing the Installation.”
