Remote Thermostat
Operating Instructions
Page 1 of 4
9/28/05
Travis Industries, Inc.
Remote Receiver Calibration
1
Plug in the receiver.
NOTE: each time the remote is re-
calibrated, unplug the receiver.
2
Remove the cover from the back of the
transmitter. Insert three "AAA"
batteries into the transmitter as shown.
Slide the code switches to a random
position on the transmitter (if desired).
Replace the cover.
ON DIP
1 2 3 4 5 6
Transmitter
Dip Switches
Transmitter
AAA Battery
AAA Battery
AAA Battery
C-P
Slide the
access
cover off.
Set these dip switches to a
random position.
ON DIP
1 2 3 4 5 6
3
At this point the LED display on the
transmitter will be on. Position the
transmitter within 1 foot of the receiver and
press any button on the transmitter until the
receiver "beeps". This indicates the
transmitter and receiver are calibrated on
the same frequency.
IF THE REMOTE DOES NOT CALIBRATE:
Remove the batteries, unplug the receiver, and
repeat the process above.
IF THE REMOTE WORKS ERRATICALLY:
If you suspect interference from a separate
device, repeat the process above, using a
different setting on the dip switches.
Receiver
ROOM TEMP
°F
°F
SET TEMP
PM
Set
Time
Cancel
:
MA
N
U A
L
O
N
/O
FF
A
T O
U
N/
F
O
O
F
Flame
Height
Fan
Speed
"Beep"
Setting the Time
ON
ROOM TEMP
°F
°F
SET TEMP
TIMER
MIN
TIMER
CLOCK
“UP” and “Down” Arrows
1. Press and hold the “CLOCK” button for 2
seconds.
2. The hour display will flash. Use the “Up”
and “Down” arrow buttons to set the hour.
3. Press the “CLOCK” button again.
4. The minute display will flash. Use the “Up”
and “Down” arrow buttons to set the
minute.
5. Press the “CLOCK” button again.
6. The “F” or “C” display will flash. Use the
“Up” and “Down” arrow buttons to select
Fahrenheit or Celsius.
7. Press the “CLOCK” button again.
Programming is complete.
Fahrenheit or
Celcius Display
“CLOCK” Button
Hour and Minute Display
MANUAL
ON/
OFF
ON/
OFF
AU
TO
