Optional Equipment
(for qualified installers only)
57
Travis Industries
4121102
100-01301
Fireback Installation
WARNING:
Turn off gas
to the appliance and
make sure it has fully
cooled prior to
conducting service.
1
Remove the glass frame
and logs.
2
Install the firebacks
following the directions
to the right (note: the
hearth plate is
discarded).
b
Remove the rear burner.
NOTE: when replacing make sure the
burner is properly aligned and the holes on
the tabs on the burner insert over the pins
on the burner stand.
Remove the rear air deflector
(two screws hold it in place).
Remove the exhaust restrictor
(4 screws hold it in place).
Remove the screw holding
the accent light assemblies in
place. Re-position the
assemblies so they are laying
flat, this allows the rear
fireback to install.
d
c
a
Remove and discard
the hearth plate
Place the rear fireback in place. The side
fireback holds the rear fireback in place -
hold the rear fireback while installing the
side fireback.
Remove the clips on both sides (these clips have key-
holes, allowing removal without removing the screw)
b
Place the side firebacks
in place. Secure using
the screws and clips
removed in step "a".
a
Place the floor
firebacks in place.
c
d
5/16" Nutdriver
